UL1263灌溉電纜
NEC article 675
Irrigation Machine. An electrically driven or controlled machine, with one or more motors, not hand portable, and used primarily to transport and distribute water for agricultural purposes.
675.4 IRRIGATION CABLE
(A)Construction The cable used to interconnect enclosures
on the structure of an irrigation machine shall be an assembly
of stranded, insulated conductors with nonhygroscopic and nonwicking filler in a core of moisture- and flame-resistant nonmetallic material overlaid with a metallic covering and jacketed with a moisture-, corrosion-, and sunlight-resistant nonmetallic material.
The conductor insulation shall be of a type listed in Table 310.13 for an operating temperature of 75℃ (1670F) and for use in wet locations. The core insulating material thickness shall not be less than 0.76 mm (30 mils), and the metallic overlay thickness shall not be less than 0.20 mm(8 mils). The jacketing material thickness shall not be less than 1.27 mm (50 mils).
A composite of power, control, and grounding conductors in the cable shall be permitted.
(B) AlternateWiring Methods. Installation of other listed cables complying with the construction requirements of 675.4(A) shall be permitted.
(C) Supports. Irrigation cable shall be secured by straps, hangers, or similar fittings identified for the purpose and so installed as not to damage the cable. Cable shall be supported at intervals not exceeding 1.2 m (4 ft).
(D) Fittings. Fittings shall be used at all points where irrigation cable terminates. The fittings shall be designed for use with the cable and shall be suitable for the conditions of service.
